In this video we’re doing a basic standing seam metal roof, I hope y’all can learn something, and just be aware this might not be the exact type of trim and panels that you have access to in your area, but some of the basic principals could still apply. Also normally you would probably have an “A” Frame roof your working on, not a Lean-to like this one, in that case line up your Rake, (Gable, or Corner) trims up at the peak, and make all the points meet. On another note, Some metal roofing shops can make custom trim so take advantage of that, Here are some of the tools we like to use, these can be found on amazon via the following links; Left off-set snips: https://amzn.to/3uJD5kF Right off-set snips: https://amzn.to/3NcSpMS Edge roller: https://amzn.to/3GtsBs6 The caulk we Love to use (super strong!!) https://amzn.to/3GzyF2r 18” hand break: https://amzn.to/3GrB0wn You can also get this in a 24” length for Hemming the bottoms of valley angles on standing seam. Our favorite gloves: https://amzn.to/3T5jp4R Our favorite roofing Shoes: https://amzn.to/482YyU4 (AKA) Hiking Boots) Power Metal Shear: https://amzn.to/46IIh5B Impact driver: https://amzn.to/3t26iqn Hand Break 6”: https://amzn.to/3R6uiRb Hand Notcher to notch the bottom edges of your standing seam panel for Hemming the bottoms if they don’t come pre-notched from the manufacturer: https://amzn.to/3Tbl88K Rubber Mallet: https://amzn.to/46HAk0A I am an Amazon associate, and may earn a commission if you purchase any of the products using the links I have listed in the description.