Part 5. In this video we will looking at loading the SMARS Arduino code into the robot, where to download the code from, how to compile and transfer the code and testing it out. Getting Started in Robotics - This is a series of videos showing you how to build your own robot, from start to finish, step by step. SMARS robots are low cost, open-source, 3d Printable robots that are easy to build, and require only the most basic electronic and programming ability to get started. Visit https://www.smarsfan.com/play/lessons for more information and show notes. Chapters 0:00 Countdown 4:58 Animation 5:11 Introduction 7:00 Overview 7:56 Code 9:54 Which Code to Load 11:54 One code to rule them all 15:37 Demo time 40:25 Studio build update 49:23 Comment of the week 52:27 Outro Link to the Bringing SMARS to life with Code video series    • Bringing SMARS To Life With Code   Link to the Keynote presentation https://www.icloud.com/keynote/0xBqkI254cg2qFU0KHnItcisA#Getting_Started_Part_1 Link to the GitHub repository for the Follow Me code: https://github.com/kevinmcaleer/follow_me2 Link to Keynote Presentation https://www.icloud.com/keynote/0HczOxJydCBsjFTX_1A8GsG4A#Getting_Started_Part_5_-_Load_the_Code Music by Bensound.com & Epidemic Sounds #Robotics #3dPrinting #Beginner